Part 1: Multiple Choice -  only one answer is correct!

---

The following information is printed on an LED light: 230 V / 6 W. Which statements about these values are correct?

 The voltage and power specifications are both peak values.

 The voltage value is the rms value and the power value is the output power.

 The voltage value is the rms value and the power rating is the peak power consumed.

 The voltage value is the rms value and the power value is the input power.

 The voltage value is the rms value and the power value is the power output.

---

What is the relation between the RMS value and the peak value of AC?

 up = √2 U

 up = 2 U

 up = √3 U

 up = 1/√2 U

 up = 3 U

---

An alternating voltage has a period time of 20 ms. What is the corresponding frequency?

 50 Hz

 60 Hz

 600 mHz

 500 mHz

 500 Hz

---

This voltage curve was measured with an oscilloscope. Which statement is correct?

Measured with an oscilloscope

The AC voltage displayed has:

 Frequency of 50 Hz

 Voltage (rms value) of 17 V.

 A frequency of 8.33 kHz

 Voltage (peak value) of 34 V

 Frequency of 5,6 MHz

 Loading …

Part 2: project task

An encoder is flanged to the 24V DC motor and outputs a square wave signal of 4 times the frequency per revolution. How this system works, you can see in the small video clip:

The circuit diagram is shown below:

Work order Encoder

 1.   For which maximum voltage (peak value!) must the diode V1 be designed if the transformer has an output voltage of 24 V?

The rotational speed is detected by a encoder, which supplies rectangular pulses to the control. The encoder signals at minimum speed and maximum speed are shown below:

work order encoder signal

2.   What is the frequency of the encoder signal at low and high speeds.
3.   How long does the motor need for a complete revolution at low and high speed?

=>  Get the solution